Common faults and treatment methods of bottled water filling machines

At present, the bottled water filling machine is a necessary equipment commonly used in the production of pure water, and it is a desalination technology widely used in the preparation of high-purity water. The pure water filling machine is assembled by pressure vessel, instrument and dosing metering pump. Knowing these assembly equipment may solve common problems that arise when producing clean water.

Common faults and treatment methods of bottled water filling machines

The bottled water filling machine is a fully automatic filling equipment for pure water plants or mineral water plants to fill 3 gallon and 5 gallon buckets. The equipment is simple to operate and can be operated by only 1-2 workers. , cover, gland and send out into one, using three-phase AC 380V power supply, widely used in cities and towns, industrial and mining enterprises and individual units. The equipment adopts a microcomputer control system and a pneumatic control system with reliable performance, easy operation and simple maintenance. The secondary pollution that may occur in the process, to achieve true aseptic filling, is currently the ideal pure water/mineral water filling equipment in China.

First of all, let's talk about the causes of the inaccurate filling amount or no material in the pure water filling machine. Whether the speed throttle valve and filling interval throttle valve commonly used in filling equipment are closed, and the throttle valve cannot closure. At the same time, whether there is any foreign matter in the quick-installing three-way control valve, if so, please clean it up, whether there is air in the quick-installing three-way control valve and the leather tube of the filling machine head, if there is air, try to reduce or eliminate the air. If the opening is delayed, adjust the throttle valve of the thin cylinder. The elastic force of the coil spring is compressed up and down in the quick-installed three-way control valve, and the elastic force of the spring is adjusted. If the elastic force is too large, the check valve will not be opened.

Secondly, there are the following reasons for the pure water filling material from the back end of the material tank, whether the material tank in the filling machine is in the center of the material tank bracket, and if the material tank changes, please re-install the position. At the same time, whether the cylinder piston and the piston rod are tight, if they are loose, please lock them. And check whether the O-ring of the material cylinder piston is damaged, if it is damaged, please replace it.

Thirdly, there are the following reasons why the piston of the material cylinder of the pure water filling production line does not return after it is pushed to the top: the position of the flow magnetic switch, press the emergency stop switch, and readjust the flow magnetic switch.

Then, when the cylinder of the pure water filling machine is not working, the fuse tube, the O-ring of the material cylinder piston, and the two magnetic switches should be replaced frequently. If the filling valve core in the filling head is stuck, the valve core should be replaced. Reinstall the position, and the position of the fixed magnetic switch. The rear magnetic switch must be fixed at the rear of the cylinder where the cylinder can work and cannot be moved.